Check in dialog empty

[rwollenhaupt]

I have an assembly I cannot check into the Vault. The Check-in process seems to be going normal until the Check-in dialog box comes up. The file I'm trying to check in is not listed and the OK button is grayed out. I get no error message. There is no unresolved link issue. I had lower level parts in this assembly that checked in when trying to check in this assembly, but the top level assembly will not display in the list  for check in. I have attached a screen shot of the dialog box. Any suggestions? Thanks in advanced.

Regards,

Bob Wollenhaupt

[tschaeferZNBXX]

Can you show us the settings you are using?

I have seen this with LOD being active that is not the master.

[rwollenhaupt]

Matt,

I don't think it's a settings issue because while in the file with the problem I can check in lower level parts. I will switch to the Master LOD and wee if that solves the problem. Thanks for the suggestion.

Regards,

Bob Wollenhaupt

[tschaeferZNBXX · Accepted solution]

We have noticed that the LOD is not always the answer but this is when I have seen this happen. 

[rwollenhaupt]

Matt,

Switching to the Master LOD solved the problem.

Thanks,

Bob Wollenhaupt