Announcements
The Simulation Mechanical Idea Board has been closed down and placed in read-only mode following a recent discontinuation announcement. Please see our supporting FAQ for more information.
Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Fatigue Wizard

benalain13
Submitted by Collaborator on ‎03-28-2014 03:02 AM Status: Gathering Support

Fatigue Wizard

Hi

 

 

2 ideas:

1.

The idea would be to keep the parameters previously set.

Actually if you have to run a second simulation, you have to enter again all the parameters...

 

 

2. During the post processing in Asim Mech GUI

    - we often have to go back to the pre processing tab, and then to the results one

    - in the fatigue results,having available only the results relative to the method we chose (EN, SN or FOS)

 

 

Regards

Report
1 Comment (1 New)
POST A COMMENT
1 Comment
Anonymous
Not applicable
‎05-27-2014 06:57 PM
‎05-27-2014 06:57 PM

I strongly agree these ideas for Fatigue Wizard.

 

Best regards,

amatsuda

Report

Forums Links

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea  

Technology Administrators


Autodesk Design & Make Report

Report a website issue