Hi all,
I've been having some issues with a RSA model.
When a try to run all the load cases (about 300) it gets stuck in the LC 1, without any prompt. When a few cases are selected it goes through the process seemly (including LC 1).
Load Case 1 is Dead Load of the whole structure. It is a large model with a number of:
Members: 3900
Panels: 4600
Nodes: 94000
There are some "isolated nodes" and "incoherent mesh on edges" warnings/error that couldn't been solved, but the model didn't had any problem calculating before.
I tried to run the model using repair mode but the problem persists.