RC Column design - manual combinations

[MUHANNAD.ABU_ABDO]

why is manual combinations off when i select column to design .. how i generate it ?

[Artur.Kosakowski]

You need to define manual combinations in the model first (Loads > manual combinations). Otherwise combinations are generated automatically by the RC Design module based on the simple cases (this is as far as I  can see your case).

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

[Rafal.Gaweda]

example movie: http://screencast.com/t/iwxoIyqYnUU

[MUHANNAD.ABU_ABDO]

I made the combinations .. when i select beam the manual combinations appear .. but when i do it with column it's not work

[Artur.Kosakowski]

Attach the model please.

[MUHANNAD.ABU_ABDO]

file is here

http://www.filemail.com/d/bnmnclhvzanditk

B.R

[Artur.Kosakowski · Accepted solution]

I don't have any issue with using the manual combinations fro RC Column design in your file.

Try to install Robot 2014 SP3 (replaced by) SP5.

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

[MUHANNAD.ABU_ABDO]

Thanks very much .. it's work with RSA 2014 SP3