Problem in deleting nodes

[adrian-om]

Hi,

I am having problem in deleting these nodes. I have deleted the whole mesh and try to delete the nodes separately, but no luck. Can you give me a hand with it?

When I try to run the model, it gives me incoherence of mesh as per those nodes.

[Artur.Kosakowski]

Hi @adrian-om

It should be enough to select them and use Edit > Delete commands. If this doesn't work could you attach the model?

[adrian-om]

I have tried that many times but I cannot delete them.

[Artur.Kosakowski · Accepted solution]

Hi @adrian-om

1. Open the file in the repair mode following this article

2. Run model verification and click on the isolated nodes warning

3. Open them in a new window and press the Delete button

If I managed to answer your question(s) press the Accept as Solution button please. This will help other users to find solution(s) much faster. Thank you.

[adrian-om]

@Artur.Kosakowski

I am getting a bit stuck with the reactions of this model.

I have modelled the slab a a really thin as the distribution of forces should be based in regards to the walls instead of how stiff the slab is. But when I am checking the reactions by hand and the reactions I get from the model, they are not the same... (pretty far away) In fact I got a warning saying that the load wasn't distributed on the slabs, but the reactions are quiet big even if they are not the one I am expecting

Can you have a look into it? I don't know why the load is not distributed, I haven't released the walls in every core as I was trying to see if it works and it is only released in one of them.