object line

[Anonymous]

Hello, I do the calculation of the Foundation plate, asked all the necessary features, want using line the walls ask how to make so that the program saw a line object as a wall? Thanks in advance!

[Rafal.Gaweda]

?????????
Check:
http://forums.autodesk.com/t5/robot-structural-analysis/api-bars-under-the-curtain-walls/td-p/460737...

or

http://forums.autodesk.com/t5/robot-structural-analysis/api-addin-walls-to-loads/td-p/4684075

[Anonymous]

I want to not take into account the weight of the wall, but the derivation of the result distribution the moments went as if there were walls , and not the line.

[Anonymous]

on the left of the model using the line object and application of load to the right model with the walls, the points are distributed differently, I want when the lines were moments similar to the moments of the walls. Is this possible?

[Rafal.Gaweda]

As far as I understood you : in the left model you modeled walls as wall objects (panels) with their stiffeness ; on the right hand side you replaced walls by "line loads" (on stifffeness). So two not comparable models from the "stiffeness"point of view gives you different results.
If it is not the case please send us \ attach the file to post.

[Anonymous]

here is a model

[Rafal.Gaweda]

This is exactly what I suspected.
Left model has walls , right with no walls
see the results for case 2 for slabs 1 2 - the same
for cases 1 and 3 where the walls are \ are loaded, results are different on panels 1 2

[Anonymous]

that is, using different functions to a single result is not to come ?

[Rafal.Gaweda]

Sorry I do not get it.

Write in Russian

[Anonymous]

можно ли через функцию линия задать стенку чтобы получить аналогичные результаты? или невозможно этого сделать?

[Rafal.Gaweda · Accepted solution]

No, not possible because line has no stiffness
See
http://forums.autodesk.com/t5/robot-structural-analysis/foundation-plate/td-p/6040451/page/2

[Anonymous]

Спасибо!