Linear releases panel

[Anonymous]

I want a releas between two panel when I release on both edges I get an instablity warning.

If i only put a release on one side the other side will have a moment, how do i solve this problem?

How does linear releases work?

[EduardoMeruvia]

Hi @Anonymous , 

Putting a linear release on ONE side only should be enough to avoid out of plane bending continuity on the slab. 

Are you looking at out of plane bending or in-plane bending of the slab?

[Anonymous]

According to the picture when I use one release the other side wil have a moment how do i solve that?

And i want no bending in de slab is that possible?

[Rafacascudo]

If possible ,zip and send the model telling which panels have the problem

[Anonymous]

Every panels ; ). The panels/walls shouldn;t have moment, how do i achieve that?

Thx for your help

[Rafacascudo · Accepted solution]

You must know that you cannot have to identical releases for all neighbor edges . At least one edge must be unreleased. See below an example.

Deleting all your linear releases and assigning a moment release to your bottom slab edges  , the results will show zero moments at the slab edges