Linear load not applied to a panel

[Anonymous]

Hi, 

I am unable to apply linear load to panel member. 

While generating LM71 moving load over a floor plate of a bridge deck, only the axels are applied to panel members and NOT the linear UDL.

Could someone suggest how to solve this.

Thanks,

Mithra

[Rafal.Gaweda]

File please.

[Anonymous]

Hi, 

Please find attached the file. Load case 4 is the moving load case.

Regards

Mithra

[Rafal.Gaweda · Accepted solution]

Why do you think so?

Check sum of reactions in each moving load step.

[Anonymous]

After analysis, there was a warning message "Linear load not applied to a panel".

Added to that, I did not check the display option for moving load vehicle.

Thanks!