instability steel desig module

[Anonymous]

Hello,

Could you help me please?

I can’t understand why the elements 17 and 18 in the attachment have instability in the steel design module

Thanks

David

[Artur.Kosakowski]

Because they are under  tension and exceeded the entered slenderness limit which in such case is calculated as for the entire length of the bar. I would suggest the changes as shown on the attached picture. Mind that this would also allow you to set the correct deflection limits.

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

[Anonymous]

Then lateral buckling parameters doesn't work for tension members, only for compression members?

 please see atacment.

Thanks,

David

[Artur.Kosakowski · Accepted solution]

Yes, this is correct however I'd say that the perpendicular beam(s)  is/are actually buckling restrains too and then they will be considered.

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.