Hello,
i have created a section using the section builder from Robot.
i have used this for a design and coming up with an error during member verification check.
Any idea what i have done wrong? thanks
Model attached using robot 2023.
Solved! Go to Solution.
Solved by Stephane.kapetanovic. Go to Solution.
hi @Tmanzz
before Saving Section to the Database and if want to justify it, it is important to provide additional information.
Best Regards
thank you @Stephane.kapetanovic
My section consist of plates that are wider than the column width. So my 'b' is not consistent.
Which dimensions will the system use to calculate the section properties? The section i have drawn or the additional information i have used?
Can't find what you're looking for? Ask the community or share your knowledge.