Hello!
I'm working in a design of a diaphragm wall through hydromill, since that, I'd like to receive some suggestions here in the forum.
In the following picture there's a scheme of what would be the parameters
1- Am I right in thinking that the best family template to develop the element is general model? (is there a way to be developed as a wall?)
2-Some of the walls will be partialy demolished. Is it right to build a void in the family and put parameters on it?
3- It is necessary to host tieback anchors in those wall, I was using the braces family because they easil are hosted in wall families, however I don't know if this family is suitable for that. I'm facing problems to set an angle as a parameter is this sort of template. I need o do that such as the craft: