Analytical Model for ramp

[wassel.eng]

I have modeled this tow slabs then the ramp using structural floor in level 2

then used "modify sub element" to add the slope to it

is there any way that I can add also slope to analytical model and attach it to level 1 on one end???

Thanks,

[erik_snell]

Floor Analytical models assume flat floors. Actually the floor will provide warnings if the slope is excessive. Unfortunately I do not know of a work around. 

[wassel.eng]

Using the slope arrow the analytical model is sloped as well but it still not attached to level 1 slab and using this solution the model as well is not attached.

actually  attaching the analytical model will help very much during analysis so I hope you have any way that I can do that.
Thanks,

[teodorb · Accepted solution]

Hi @wassel.eng,

Please check out this thread. It might help you.

https://forums.autodesk.com/t5/revit-structure-forum/align-analytical-slab-to-modified-sub-element-s...

Kind regards,