Hi,
Any idea of get the length of electrical conduits inside walls?
I created parameters (yes/no) in my conduits and fittings to mark those are on walls, but I can't do it on tubes there aren't fully inside walls, like the tube in the bellow image. This one have just a small part inside it.
You want to know what portion of a conduit is running thru a wall out of the entirety of the run?
like @iainsavage suggested you can do a clash detection to see where there at. but that wont give you distances or lengths. Only thing can think of is to Break the conduit run at those locations and use your Y/N parameter on the segment in the wall. You can make a Coupling/Joint that is minimal in size so you wont see it and the wall line would cover the break in the pipe if you wanted to hide that.
Howard Munsell
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
the Interference checking tool inside of Revit will show you where the conduit is penetrating walls/floors. it will not give you lengths, but will display there location.
Howard Munsell
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
It showed me the elements that pass inside walls, but not only their part on it. I'm thinking Revit just can't do it.
Hello,
Without using Dynamo or another plug-in, it is not possible.
Fábio Sato
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
