Draw Order

[mwoodsonUUZVA]

I am working on a kitchen layout and need to display plumbing drains on a 2D sheet. When I place the drain symbol on the sheet, they look fine. When I print, the linework gets mixed up and SOME symbols are covered by the equipment they serve while others are not covered. In CAD, I could use the draw order option, but this seems to not be available in Revit. Any tips would be great, thanks!

[ennujozlagam]

when you print try/select raster processing and see if helps?

[hmunsell]

couple questions:

• is the equipment coming from a Link?
• is it the same equipment each time covering the drains?

[mwoodsonUUZVA]

I will try this tip today, thank you!

[mwoodsonUUZVA]

The equipment is not from a link, I placed them in the model myself. The issue seems to be consistent with floor troughs, and grid lines.

[iainsavage]

Post some screenshots please.

[mwoodsonUUZVA]

[iainsavage]

Are these two floor drains? If so, are they both the correct way up or is one of them upside down?

If possible please upload your model file or a cut down version of it so that we can open it and check settings etc.

[hmunsell]

what would happen if you offset them so there raised just a little, just 1/8"?

or, alternatively, what happens if you Hide the floor?

[mwoodsonUUZVA]

I raised them of the floor 1/8" all the way to 2" and visually there was no differences. I will try to hide the floor and see if that works.

[iainsavage]

Please respond to my earlier post:

"Are these two floor drains? If so, are they both the correct way up or is one of them upside down?

If possible please upload your model file or a cut down version of it so that we can open it and check settings etc."