Curved Model Edge not Displaying

[lleblancSBBXJ]

See image below.  Can anyone help me get these edges to display correctly?  I've run into this problem with user-created families in the past and resolved it by using masking regions, but now I'm having the issue with pipes.  This only seems to happen in elevation or section views.

I tried turning hardware acceleration off with no success.  I'd really appreciate some input if anyone has suggestions.

[lleblancSBBXJ]

Well, I just found the article below.  It looks like this is being "investigated". 

https://knowledge.autodesk.com/support/revit/troubleshooting/caas/sfdcarticles/sfdcarticles/Edges-of...

[ToanDN]

Sorry but I can't replicate.

Plan:

Section:

[lleblancSBBXJ]

@ToanDNThanks for the response.  It doesn't happen in all views, and I can't determine what causes it.  I have other views in the same project where this isn't an issue, but I've seen the issue in Revit 2021-2023.

[iainsavage]

Its usually because the pipe/fitting is not exactly parallel to the view plane, even being off by a very small fraction can cause this.