Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Created a Duct Accessory and can't choose what side it attaches to once loaded
Created a Duct Accessory and can't choose what side it attaches to once loaded
I'm using Revit 2019, but have the same problem in earlier versions. I have created a duct accessory family that when loaded into my project randomly picks the side of the duct it will attach to but I can't choose/change to the opposite side if needed. Is there a control I'm missing that will allow this to happen?
Hey, i don't know what exactly you want to do with the Duct Accessory....
According to my knowledge it should have 2 connectors so it can fit into the duct and connector direction should also be pointing outside.
And the Part type Should be "break into" depends on your requirement.
In your case the Duct Accessory has one connector pointing inwards and part type as "Attach to"...This means you can only place duct accessory in one phase.
Please find the attachment which i have modified. I have done in Revit 2020.
Please check and get back if i have misunderstood anything.
