Cable tray fittings hatch problem

[s301643]

Hello, 

I'm struggling with this problem: 

I applied a filter for teh cable trays but it some fittings are not fulfilled.

How can i solve this?

Kind regards, 

Cosmin

[SdinizF]

Which filter did you apply?

[s301643]

Hello, 

these are the filters I applied 

[SdinizF]

I'm using a similar filter for conduit and conduit connections here and haven't had any issues like this.

Try applying the filter on other views, sections, 3d... to compare if the issue also occurs.

My view settings:

Detail level: Fine.

Visual style: consistent colors.

My plan properties settings:

[ToanDN]

Are they the same fitting family?

[s301643]

Yes, same family. 

In 3D view both are transaparent, if this may help

[ToanDN]

---

@s301643 wrote:

Yes, same family. 

In 3D view both are transaparent, if this may help

---

Does the blue fitting have any override by element in view?

[s301643]

No, no overrides

[s301643]

I use the same filter for the conduits, too, but with conduits doesen't happen

[sragan · Accepted solution]

If the filters are set up correctly, and they are the correct families, then maybe something else is overriding the one elbow.

Are both elbows on the same workset?  Are they both on the same phases?  Is one higher or lower than the other?  Maybe it is using the beyond line style or something like that.

If none of that works, what happens if you change to family of that elbow to match the red ones?  Does it work then?

[s301643]

The prbolem was in the height of the cut plane. It was stupid but I didn't thaught about it. 

It was sufficient to elevate the cut plane and the problem was solved.

Thank you all for the solutions! 

[s301643]

The problem was in the height of the cut plane. It was stupid but I didn't thaught about it. 

It was sufficient to elevate the cut plane and the problem was solved.

Thank you all for the solutions!