Attaching Set Screw Connectors to Panelboards

[mnye480]

I have a question about attaching steel conduit connectors to a panelboard. Not the conduit connector for a family. 

My project has 1 - 2" EMT conduit and 8 - 3/4" EMT conduits leaving the top of a panelboard. Is there a way to automatically have a set screw connector terminate to the panelboard when I make the conduit connection? Or do I have to first connect the conduit and then place a set screw connector on each conduit one at a time?

[TBridgeG488B · Accepted solution]

You can’t use the Conduit Surface Connector to start a conduit that would place an EMT set screw connector between the conduit and enclosure.

The only way I know would be to insert the EMT connector family to the face of the panelboard and draw the conduit from a Conduit Individual Connector in the EMT connector family.

This way it it easy to move the conduit location on the face of the panelboard.

The Conduit Surface Connector doesn’t allow repositioning unless you Disconnect.