Wall wrap at join

[chughes]

Is it possible to get finish layers of differing thickness and finish to wrap at core aligning walls?  I have tried this solution (http://forums.augi.com/showthread.php?134582-Can-t-get-brick-to-wrap-wall-join) but it didn’t work.  I have experimented with wraps and wrap joins, but cannot get the intended result.

See below for explanation.

3D image for intent clarification

Wall properties are below

Thanks much!

[cbcarch]

Not sure if you have already done so, but try clicking "wrapping at ends" and set to Exterior ( or both?).

[chughes]

I have tried.  It doesn’t work.  It will wrap at the unattached end, but not at the join between the two aligned walls.

[barthbradley]

I think you're speaking to one of my biggest frustrations. I just resolve it by just placing a very short perpendicular wall composed of the layers I need to "wrap".   It's always a pain in the butt.  

[barthbradley · Accepted solution]

.

[ennujozlagam]

wall wrap

[ennujozlagam]

wall wrap

[chughes]

This is as close of a solution as I can get.  

Thanks Barth!

[chughes]

@ennujozlagam I tried the proposed solution, before and after your post.  I just wind up with a hot mess. 😕  The structure wall layer of the short wall wants to push all the way through to the finishes on both sides.