Wall Mass Opening

[zs-17]

Hi

I would like to remove the interior part of Wall Mass and I can't find a way. 

[barthbradley]

This?

[zs-17]

Yes. How to do it?

[barthbradley]

I attached an RVT to that post as well. 

[barthbradley]

[zs-17]

 I received a photo without detail so I didn't understand.

[barthbradley]

---

@zs-17 wrote:

 I received a photo without detail so I didn't understand.

---

I posted an RVT too.  Here it is again.  Let me know if attachment doesn't get transmitted with post.  Maybe there's a Forum issue today.  

[zs-17]

Thank you for the rvt file also. But I still look to learn how to do it.

[barthbradley · Accepted solution]

Just edit your lovely in-place mass and add a void mass to cut the solid mass. Then finish and close out of in-place mass edit mode, select your wall by mass face and press "update to face" on the contextual tab.  Bada bing. 

[zs-17]

I did this and get these messages

[barthbradley]

I suspect the Void Form is not intersecting the Solid Form.  

[zs-17]

There is an intersection.