Voids not cutting in views

[dariawerynska]

Hi there,

I have shaped a roof (using sweep) and I wanted to cut some voids out of it. I managed to have it cut properly but the cutouts are visible only in 3D view. No elevation view shows it.

I can enter the edit mode of these voids but it won't show anyway 🙄

Any ideas?

[Anonymous]

Can you post an image of your roof?  It may be easier to see your problem.

[martijn_pater]

Select the voids / cutouts (outside of edit mode) and check phasing properties. Edit: did you make the cutouts in a roof or in the same in place model? With the latter it is not your answer...

FYI you can also draw a roof by extrusion, are you familiar with that option? Under architecture tab -> roof drop-down.