Toposolid schedule separate cut and fills

[dominic]

I am trying to schedule separate cut and fills in a topsolid. Is there any way to schedule cut and fill and area for each cut, and then the total?

I am using in place void for the cuts.scheduleToposolid

[Alfredo_Medina]

What do you mean by separate cut and fill for each cut, if both changes are cuts?

[dominic]

I wanted to create a schedule which lists each cut/fill as a separate line item which can be identified by its name i.e.:

NAME               CUT       FILL       AREA

----------------------------------------

Cut 1                5.0m3    0.0m3   7.0m2 

Cut 2                10.0m3   0.0m3   9.0m2 

-----------------------------------------

TOTAL               15.0m3   0.0m3   16.0m2     

We used to be able to schedule pads as separate items with topography.

[dominic]

And also listing the area for each separate cut. In NZ we use the areas of the cut as well as the volume for Resource consent (planning) drawings.

[barthbradley]

Join the geometries together. Join geometry removes volume at the union. 

[dominic]

I wanted each in place void (which cuts the topsolid) to be itemized separately in the schedule.   

as per:

NAME               CUT       FILL       AREA

----------------------------------------

Cut 1                5.0m3    0.0m3   7.0m2 

Cut 2                10.0m3   0.0m3   9.0m2 

-----------------------------------------

TOTAL               15.0m3   0.0m3   16.0m2 

[barthbradley]

---

@dominic wrote:

I wanted each in place void (which cuts the topsolid) to be itemized separately in the schedule.   

as per:

NAME               CUT       FILL       AREA

----------------------------------------

Cut 1                5.0m3    0.0m3   7.0m2 

Cut 2                10.0m3   0.0m3   9.0m2 

-----------------------------------------

TOTAL               15.0m3   0.0m3   16.0m2 

---

Okay, so filter the schedule to show only the data you want it to show. No biggie.    

[dominic]

I might be missing something pretty basic, but I have attached a RVT file to illustrate the issue. Also when I pick the void cut in the toposolid it doesn't register the cut and fill, although the parameters are present in the type

[Alfredo_Medina]

To obtain what you need, don't use model in-place, but toposolids. Create a toposolid by sketch, for example, as a rectangle. Revit will show a message saying that toposolids are overlapping. Then, in section view, locate the toposolid where it needs to be. Then do Modify > Cut geometry > select the main land > select the small toposolid.

Now check the schedule. Each toposolid will show data. 

[barthbradley]

Is this what you are after?

[barthbradley]

Here...just check it out. I think it's self-explanatory.