Stairs Riser not lining up with Stinger

[Anonymous]

My riser and stingers are not lining up and it's driving me slightly mad.

I'm hoping someone can help me elucidate this. I've attached the file with the single stair.

[barthbradley · Accepted solution]

deselect end with riser. 

[Anonymous]

Thanks @barthbradley, it seems to work for new stairs runs.

Do you know if it is possible to deslect it for existing stairs? I can't seem to find the option and the documentation not helpful on this topic.

[Anonymous]

Nevermind, I got it. I had to TAB select the stair part of the stair instead of the assembly.

Thanks! 

[barthbradley]

Yes you can set it as default. When you start a new stair, open the drop-down box under "Stairs" in Properties and select "New Stairs: Run" and then deselect "End with Riser." That will remain the default until you redefine "New Stairs:Run". 

[Anonymous]

Solving problem 1 created another problem...

Without the final riser, all the stairs say they are mising a riser.

I've also noticed that adding the riser, extends the thread by 1-1/4" for some reason.

Do you know if there is a way to get the final riser without the weird 1-1/4" extension?

Thanks!

[ToanDN]

That is the Nosing distance.

[Anonymous]

I was able to remove the nosing distance and the end of the stair looks great, but now the noses are all screwed up.

Is there a way to get a good stairs for both nosing and end riser?

[ToanDN]

Don't you stairs have a top landing?

[Anonymous]

Yes

[ToanDN]

Add the top landing see if it helps.

[barthbradley]

Highlight the Carriages and select a different Upper End Cut