Stairs Railing

[d.ola]

Does anyone know how i could create the balusters such that they adjust to the Top Banister. Thanks in advance

See Picture Attached 

[barthbradley]

Are you talking about this? 

Landing Height Adjustment:

[oladamilola]

No. I meant this

 

[barthbradley]

I'm not clear on what I'm looking at. It does look screwy though. 

Post the File.  

[oladamilola]

Hi @barthbradley Here's the file. Thanks

[barthbradley]

This?

[ToanDN]

[oladamilola]

Yess. The only issue I have is the baluster extends beyond the boundaries I drew at the beginning and again at the end of the railing. Do you know of a workaround to trim the overshoot?

[barthbradley]

Change the offset from Host. No? 

Currently, the Base Offset is -5m.  

[ToanDN]

---

@oladamilola wrote:
Yess. The only issue I have is the baluster extends beyond the boundaries I drew at the beginning and again at the end of the railing. Do you know of a workaround to trim the overshoot?

---

So your upper run railing and lower run railing are on the same plane is the intent?  A workaround is using a curtain wall and edit profile for that railing.

[oladamilola]

This doesn't work. i get the highest chance with all balusters extending to the lower Railboundary (and beyond) with values starting from -0.5m.

[oladamilola]

Yes. That's the intent due to space constraints.
Phew. I've been trying to avoid the curtain wall workaround. But just might have to resort to it

[barthbradley]

What do you mean "it doesn't work"?  Maybe I'm not understanding what the aim is here. 

[oladamilola]

It doesn't work was in reference to changing the Base Offset like you suggested.

And the overshoot i mentioned is marked Red with the attached image. The aim is to do away with the overshoot