staircase direction

[amirhossein.jafarii]

Hello All,

I have a question.

I want to drag the arrow of the staircase I marked to the end. The architect is so obsessed  that the arrow has to go to the end of the staircases.

Thank you all for your help!

Amir

[_Vijay]

@amirhossein.jafarii  It will show only up to view range cut the stairs. if you need further you can use annotation like details lines or detail family.

[amirhossein.jafarii]

Thank you,

In fact, the stair I want to show to direction goes down and the cut plane should be 4' above the second floor. 

now I could fix the issue by changing the family as well. 

but what is shows is "straight up". what if I want to show straight down? 

 like instead of showing from where we go up. 

it show the direction of going down.

Thank you,

Amir 

[ennujozlagam]

you wrote

but what is shows is "straight up". what if I want to show straight down?

like instead of showing from where we go up.

it show the direction of going down.

just pick your stair path > go to properties to change. thanks

[barthbradley]

No need to change the View Range for the View. Instead, draw a Plan Region around the Stairs and adjust the Plan Region View Range. TIP: Other Levels can be used in Plan Region View Range Settings.  

Both these Stairs are on Level 1. Top Stair surrounded by a Plan Region and the bottom Stairs use the normal View  Range Settings.