Stair landing plywood

[JGuliker]

Is there a way to change the thickness of the plywood on the stair landing only without making the landing a floor? Our stair treads are typically 1" and the landings are 5/8" plywood. 

[ToanDN]

Edit the Landing type and untick Same as Run box, then you can make it however you want.

[barthbradley]

[JGuliker]

Yes, there is an option to change the thickness on the landing if you use the automatic stair tool, but I usually like to sketch my stairs. It works much better. There is not option to change the landing plywood when sketching the stair.

[ToanDN]

Sketch the runs and landings separately within the stairs.

[barthbradley]

---

@JGuliker wrote:

Yes, there is an option to change the thickness on the landing if you use the automatic stair tool, but I usually like to sketch my stairs. It works much better. There is not option to change the landing plywood when sketching the stair.

---

So the landing are not part of the run?  You mean you're Landing are Floors?  Or, actual Landings.  Either way, the answer is yes. If landing, do it as I showed in my screenshot. If Floor, model the layer thicknesses as you normally would.  The riser height will not be affected.