Sloped & Tapered Wall

[119348566]

How would I model a Tapered wall that stays flat at the top but the base varies from 4.5m to 6m deep? Any help is appreciated

[ToanDN]

Do you mean the base has different thicknesses or different elevations?

[119348566]

Different elevations

[ToanDN]

Then model a normal tapered wall and attach it's base to the sloped slab. If you don't have a sloped slab, edit the wall profile, or draw a sloped ref plane and attach the wall base to it.

[119348566]

Is there any chance you could show me some step by step? Im not familiar with how to attach to the bottom

[ToanDN]

Select the wall, click Attach Top/Base button on the Ribbon, choose Attach Base, select the sloped slab at base 

[119348566]

By creating a sloped ref plane and adding the base of the wall to it would it stretch the wall downwards until it came into contact with that slope of the plane?

[ToanDN · Accepted solution]

---

@119348566 wrote:
By creating a sloped ref plane and adding the base of the wall to it would it stretch the wall downwards until it came into contact with that slope of the plane?

---

No. You don't have to stretch anything.  Use Attach Top/Base to attach the wall base to the plane.

And I just looked at your picture, you clearly have a sloped slab then just attach the wall base to the slab.

[119348566]

Alright that makes sense, Thanks a lot!

[119348566]

Ive come across an addition to this problem, how would i attach the base of the wall to extend below the slab rather than stop at the top of the slab?

[ToanDN]

Go to an elevation, draw a ref plane at the bottom of the slab, attach the wall base to it.