Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
There is no way to make the far clip dashed line itself always visible in plan view. However, you could draw four detail lines where the clip is, then create two global parameters, one for the far clip's depth and the other for its width. You would still have to manually change these if the section view's location or the far clip depth or width changed, but it would be fewer steps than manually dragging the lines one at a time.
There is no way to make the far clip dashed line itself always visible in plan view. However, you could draw four detail lines where the clip is, then create two global parameters, one for the far clip's depth and the other for its width. You would still have to manually change these if the section view's location or the far clip depth or width changed, but it would be fewer steps than manually dragging the lines one at a time.
