
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I am working on a project that has some sweeps for electrical equipment. When I cut a section through this "model in place" component that is made as an electrical equipment category it does not display as I would like. See section.jpg image attached.
Is this a function of the way this specific category is displayed? If I make a new sweep and make it as a generic model category it displays as expected. I guess then I have two questions then. The second being. Can I change the category of these model in place objects? I do not want to recreate them all just so I can show them properly in section. Thanks.
Regards Peter.
PS - in the section, it is strange that it looks correct on one side but not the other. It is like it is cutting the view farther to the bottom of the screen and seeing the end of the sweep, and then not seeing any of the geometry that is cut on the other side. Unfortunately that is not something I can adjust in the section itself. see section2.jpg image attached.
Solved! Go to Solution.