Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I made an octagon roof at the thickness of 125mm. In the elevation I can see the thickness of the roof. However, in the sections it shows that the bottom of the roof is flat. ( no thickness) I have tried messing around with the roof properties, but it it doesn't seem to work. Any suggestions would be appreciated.
I made an octagon roof at the thickness of 125mm. In the elevation I can see the thickness of the roof. However, in the sections it shows that the bottom of the roof is flat. ( no thickness) I have tried messing around with the roof properties, but it it doesn't seem to work. Any suggestions would be appreciated.
I don't see any problems either. Do you mean the walls not reaching the underside of the roof? If so, select the walls and attach their top to the roof from the wall menu ribbon.
I don't see any problems either. Do you mean the walls not reaching the underside of the roof? If so, select the walls and attach their top to the roof from the wall menu ribbon.
Yes, I misread the the section drawing. Thank you for pointing that out. I just realized that the thickness was showing properly in the top of the roof.
Yes, I misread the the section drawing. Thank you for pointing that out. I just realized that the thickness was showing properly in the top of the roof.
