Revit does not join top railing properly after setting offset from path to negative value

[m.milovanovicJM673]

Hi all,

I am struggling with top rail joint in stair's railing I created.
If offset from path is set to 0 Revit creates top rail properly but I set offset from path to -2.5cm, which I need to properly attach raling's balusters to concrete slab under stair's finishing,Revit makes incorrect joint in top rail.

Does anyone have idea how to correct this?
Regards

[alan_eu · Accepted solution]

Most of the time I prefer to model in place these kinds of detail. Unfortunately, railings, stair or ramps haven´t the best personalized fine configurations 😞

[syman2000]

You can try to switch from Gooseneck to Simple and see if that gives you better result.

[m.milovanovicJM673]

Hi Syman,

yes,I tried that... doesn't solve the problem....it seems Revit doesn't have good solution for automatic railings...

[m.milovanovicJM673]

Hi Alan, I was afraid I will hear that as only solution....

[alan_eu]

@m.milovanovicJM673 Revit has many options to configure railings, but sometimes we can't 😞

A good item to the wish list would be an edit 3D sketch path do draw railings like a  semi-manual-mode... 

[syman2000]

sometimes it depends how the railing is constructed. Share the railing sample so we can take a look.