Revit 2018 inclined floor

[Anonymous]

How do i make an inclined floor with the thickness of the floor getting smaller through the incline? I would like to have 200 thickness on one side and 180 thickness om the other with and the incline should be -20. 

[cbcarch]

A few methods:

-Model in-place>Extrusion.

Sketch the profile needed, then create the floor., Grip edit length in Plan view. Set Family Type to Floor.

-Use an in-place Void to cut a floor that is level.

-You could also try to use a Ramp.

-You can use edit sub-elements/points to give the top surface of the floor a slope as needed.

-You can use a slope arrow ( this will "tilt" the whole floor, top and bottom surfaces)

[ToanDN]

Create a 200 mm flat floor and edit sub elements to bring the end edge down 20 mm.

[Anonymous]

Can't i just change the elevation at the bottom? As in the picture, but how do i change the setting when it is grey?

[ToanDN · Accepted solution]

---

@Anonymous wrote:

Can't i just change the elevation at the bottom? As in the picture, but how do i change the setting when it is grey?

---

See below.  And if you read my first post carefully you would notice I said "flat floor".

[barthbradley]

How'd I do @Anonymous?  

[barthbradley]

.

---

[Anonymous]

Thank you that worked 😄