Revit 2014 Custom Block pattern Help

Revit 2014 Custom Block pattern Help

Anonymous
Not applicable
828 Views
3 Replies
Message 1 of 4

Revit 2014 Custom Block pattern Help

Anonymous
Not applicable

I have a special requirement for a CMU wall, with a 2"x6" stud wall.

I am building an exterior wall for a residential home model.

Brick exterior, basically is 3 1/2" width

1/2 mortar joints

I have attached a pic, of what the pattern should look like (created in msWord)

1/3 running bond, with 2 sizes of concrete block.

I saw somewhere on line, the program for the repeat, but am unable to find again

Michael - Toronto Canada

0 Likes
Accepted solutions (1)
829 Views
3 Replies
Replies (3)
Message 2 of 4

Alfredo_Medina
Mentor
Mentor

What is the repetitive pattern? Can you draw a rectangle over that image that defines what is repeated?


Alfredo Medina _________________________________________________________________ ______
Licensed Architect (Florida) | Freelance Instructor | Profile on Linkedin
Message 3 of 4

Anonymous
Not applicable

pattern as attached

scan0002.jpg

0 Likes
Message 4 of 4

Alfredo_Medina
Mentor
Mentor
Accepted solution

Then, the pattern is this:

 

2-16-2014 4-24-58 PM.jpg

 

 

I would begin editing a surface pattern for masonry blocks, and figure out how to repeat one course, and add the addtional row. It might take some time to figure out the instructions, but it shouldn't be too difficult.

 

Other than that, you could try with Hatch22.


Alfredo Medina _________________________________________________________________ ______
Licensed Architect (Florida) | Freelance Instructor | Profile on Linkedin