piping around wall
There is no offset option to use while picking points, but it would be useful if there were. I approach it in a schematic way...sketch the basic path without regard for the precise placement of the first set of pipes. Then use the temporary dimensions that appear when selection a section of pipe and fine tune the location of the pipe(s) around the perimeter. I can use the Parallel Pipe tool to create additional pipe(s) offset a specific from the initial run.
Steve Stafford
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
sorry...forgot about Justification (ribbon button), it has a horizontal offset option so you can pick the face of the wall and set the pipe a specific distance from your pick points (only sees centerline of wall so have to work out the offset)...and direction affects the side of the wall so you have to draw it in the correct direction. Space bar does not flip the orientation.
Steve Stafford
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
