Pads don't show the cutting pattern underneath them

[eduardo.schoenau]

I want to see the fill cut pattern underneath the pad, but when the cut plan goes under the topography region, only a white fill appears

[barthbradley]

Cut the Toposurface with a 3D Section Box.  

[ToanDN]

Lower the view range bottom and depth to capture the lower pads.

[eduardo.schoenau]

sorry, you asking an image of this 3D section box?
there supose to be an filled underneath the pad, and seems to be only an empty space.
The point is, how i can show it in the floor plan?

[barthbradley]

I thought you were trying to view your Topo from underneath in 3D View. If you are talking about Plan View, lower the View Range Depth/Bottom.

[eduardo.schoenau]

thanks, but didn't work

[eduardo.schoenau]

this is the only solution i'll have found, but i'm not suppose to define the view range based on that (plan region doesn't work too)

[barthbradley]

---

@eduardo.schoenau wrote:
thanks, but didn't work

---

View Range doesn't capture them?  Strange. Post your file.

[barthbradley]

---

@eduardo.schoenau wrote:
this is the only solution i'll have found, but i'm not suppose to define the view range based on that (plan region doesn't work too)

---

I'm confused. You are not supposed to define the View Range to capture the Pads, but the View is supposed to show the Pads?  

[eduardo.schoenau]

that's another file, with the same problem, the view name is "terreno"

[eduardo.schoenau]

it's supposed to show the ground underneath the pads, not the pad itself

[barthbradley]

---

@eduardo.schoenau wrote:
it's supposed to show the ground underneath the pads, not the pad itself

---

Is the "Ground" outside the View Range?  

...by the way, you can turn off PADS through VGOs if you don't want them shown - but you still need to adjust the View Range to see the infill bottom in the View.  

[ToanDN]

.

[barthbradley]

[eduardo.schoenau]

thanks @barthbradley for the patience, believe me, i'm trying my best here 😬.

take this other example, i have 3 pad's, for three buildings, in differente levels,

look the level 1, i'm seeing the empty space underneath the other pad's,

but i want the cut plane passes by 1,2m from level 1, because that how the view works.

[RDAOU]

...

[eduardo.schoenau]

 

[barthbradley]

I'm not following. Everything is visible if it's within the View Range.

...a View will not show something that is outside of the View Range.  That's a good thing.  Otherwise, our Plans for a multilevel building would look like sh*t.  Know what I mean?  I you need a Plan that locates Building Pad Cuts. then you create a View with a View Range that will capture the cuts.  

[ToanDN · Accepted solution]

---

@eduardo.schoenau wrote:

 

---

I think you need to place a filled region with the same color/pattern as the material to fix the view.

[eduardo.schoenau]

ok, but the floor plan for level 1 and 2 doesn't show the right representation, look that now i put a door in each building.

I'm not supose to change the cut plane, it must cut in by 1,2m.

Only if i change the whole cut plane and make an plan region, but i don't think that's a logical workflow.