Monolithic Stair

[emersongonzalez1999]

So I have a Base Monolithic stair which depth is 52 inches and when I created another stair it has the same depth of 52 but when I change it to 7 inches it creates a hole kinda to the one that was already created. I want the stair to be different depths but not to affect the other.

[RDAOU · Accepted solution]

@emersongonzalez1999 

You need to do the following

1. Start Stair
2. Edit Type
3. Duplicate the Type and Rename
4. Edit Run Type
5. Duplicate and Rename >> Change Structural Depth of the new type
6. Apply/OK to Finish Run Type Edit 
   • Repeat for the Landing if needed
7. Apply/OK to Finish Stair Type Edit
8. Place new Stair type

[emersongonzalez1999]

Thank You So Much For The Video Tutorial