How to move only 1 edge of a sweep? Or how to rotate the sweep?

[alex.doychinov722SP]

SIDE VIEW:

TOP VIEW:

I have a sweep that I created off of a point cloud that I inserted into the model. The point cloud (in red/orange) is not 100% horizontal so I need to rotate my mass to match the angle. However, I cannot rotate it and when i go to rotate the profile of the mass, I also cannot rotate that.

I also tried to grab only the top right edge and bring it down, but that also brings down the top left edge. So essentially, bringing down one of the edges brings down the whole top face.

Any suggestions?

[eizinmyat]

Hello,

How about editing the swept path?
select sweep mass > modify > sketch path to modify the path.

[alex.doychinov722SP]

Yes this is something I tried but I also cannot rotate the sweep path.

[azad.Nanva]

use the Void to cut it.

or use Swept Blend: