How to create a roof with different levels?

[BugFinder]

How do you create a roof with different levels?

The bottom of the roof on the left hand side should be sitting on top of the wall.

If it were a pitched roof I could see how you would do it with a Roof by Extrusion however since this is a pitched roof I cannot see how you would do this as the command sits on a elevation which is flat all the way across.

How do you tell it the roof should be raised on one side?

[barthbradley]

Select the eave and enter an Offset from Roof Base

[ToanDN · Accepted solution]

Edit the roof sketch boundary and you can assign different Offset from Roof base to different segments.

[barthbradley · Accepted solution]