Help with ramps

[cbt990]

After my adventure moving the whole building today, this should be an easier one. every time I try to adjust the ramp landing to how the red lines are shown, it fails to rebuild. is it possible to do it like this? 

[barthbradley]

I'd put a floor there and shape-edit it (e.g. Modify Sub-Elements).  

[ToanDN · Accepted solution]

[cbt990]

How did you achieve that? 😕

[ToanDN]

---

@cbt990 wrote:

How did you achieve that? 😕

---

The key is to draw the ramp in a way that the runs meet exactly from the get go.  If they don't meet and you need to move a run then it will fail.

To do that you may need to:

- create some guidelines before hand if you draw the ramp using runs and landing

- or, draw the ramp by boundary sketch, not runs

However, for a cleaner rail transitioning (both in Revit and fabrication), it is advisable to NOT have the runs meet exactly at a corner, and have landing extension on one or both sides.