Creating a Roof with Different Eave Heights -Trouble

[Anonymous]

Greetings,

I was following the instructions for Creating a Roof with Different Eave Heights (Link) 

But got trouble with the procedure when joining the two roofs, because you need to pick a line and a surface, and that is not there in the instructions.

How can i do the roof in the link? (Image below)

[mariano_biagioli · Accepted solution]

Hi, the link in your coment isn´t working.

Are you using the Join/Unjoin Roof tool?

Here is an example to use it with diferent eaves heights

Please, if the answer helped you, mark it as a solution 😊

[constantin.stroescu]

your Roof can be done from a single Roof by Footprint.

The result is this:

[barthbradley · Accepted solution]

Offset from Roof Base. Then add overhang as Roof by Extrusion.  

[constantin.stroescu · Accepted solution]

and here are the steps:

https://knowledge.autodesk.com/community/screencast/820e7c91-52af-446b-879d-bc5341859446

[Anonymous]

Sorry, the link was: https://knowledge.autodesk.com/support/revit-lt/learn-explore/caas/CloudHelp/cloudhelp/2018/ENU/Revi...

They do the procedure joining two roofs, however, your answers were very helpful, thanks for your time. 

[barthbradley]

Do you want to mark mine as the accepted solution as well, since it was the same as @constantin.stroescu?   

[Anonymous]

Sorry, I missed it, thank you very much

[veeresh.huvinahalliACK3L]

How to can we create above same roof with different pitch value given to the plate height value?

[veeresh.huvinahalliACK3L]

How can we use above same solution with scenario for non defining slope line.

[veeresh.huvinahalliACK3L]

How can we use above same solution with scenario for non defining slope line.