Re: connect roofs

Anonymous · ‎03-25-2019

Hi. Is there a way to connect these two roofs. One is roof by footprint, the other is roof by extrusion and they don't have intersection lines.

Thanks

ennujozlagam · ‎03-25-2019

hello, you can try to use void extrusion/sweep then use cut geometry. i don't think you can join them. thanks

Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.

Anonymous · ‎03-25-2019

Hi. it doesn't help much since there are no intersection lines can't do a precise void sweep or void extrusion. Yes, I just want to trim the roof not to join it

kittugs143 · ‎03-25-2019

Hello,

One roof with a sloped roof and another by face extrusion but if you noticed that the bottom of the roof is the same.

So if need to join this roof just give level offset for the roof (1/32") then add you can use join roof and hope it works.

Please find the image for more info :

Best regards,

G.Sivakrishna

Product Specialist - AEC

barthbradley · ‎03-26-2019

You need to Align Eaves.

Plus, draw your Profile this way:

connect roofs

connect roofs

Forums Links

Post to forums