Hi everyone,
I have created a custom bifold mesh panel which will be used as a parametric facade. Upon attempting to load this family into the generic pattern based model I get the error 'can't make type "adaptive bifold attractor"'. I have been selecting the correct four reference points with the fifth attractor point above. Is there any way around this? I am trying to array these bifolds along the pattern based model and then parametrically adjust their arrangement/angle.
Any help would be much appreciated 🙂
Process:
- loaded adaptive bifold attractor into attractor points model
- selected place on face
- placement plane: level 1
- error when selecting reference grid points and attractor points --> 'can't make type "adaptive bifold attractor"'
