Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Adding nodes to a curved surface to apply a adaptive components to?
Adding nodes to a curved surface to apply a adaptive components to?
Hi,
I am trying to create a complex standing seam curved roof which curved along the section and in plan. For this reason the change in direction can only be achieved using 3 point linear adaptive adaptive component. The problem I face is that where the divided surface interfaces with a corner it does not place a node so the pattern stops at this point. Please see the screenshots attached to better understand.