I am writing a program that creates Stucco walls in Revit. The height (or z-coordinate) to where the stucco goes is always the highest point in the room, at a given (x,y) coordinate
I calculate the points by creating 3d curves from (x,y) segments in the room. The algorithm seems to work quite nicely, however, if I try do do it more accurate I get an exception. It seems to have to do with the length of the curves
Does anyone now if there is a minimum length for curves when you use and IList<Curve> with the call Wall.Create
This works:
xyz: 13,94 23,37 19,72 xyz: 24,62 23,37 19,72 length: 10,6800841582423
xyz: 24,62 23,37 19,72 xyz: 24,62 23,37 28,31 length: 8,59580052493438
xyz: 24,62 23,37 28,31 xyz: 21,28 23,37 28,31 length: 3,33752629945071
xyz: 21,28 23,37 28,31 xyz: 21,11 23,37 28,31 length: 0,166876314972534
xyz: 21,11 23,37 28,31 xyz: 20,94 23,37 28,22 length: 0,191533404495919
xyz: 20,94 23,37 28,22 xyz: 14,27 23,37 22,42 length: 8,8445314248311
xyz: 14,27 23,37 22,42 xyz: 14,10 23,37 22,27 length: 0,221113285620777
xyz: 14,10 23,37 22,27 xyz: 13,94 23,37 22,16 length: 0,202839691919588
xyz: 13,94 23,37 22,16 xyz: 13,94 23,37 19,72 length: 2,43888602246705
and this fails
xyz: 13,94 23,37 19,72 xyz: 24,62 23,37 19,72 length: 10,6800841582423
xyz: 24,62 23,37 19,72 xyz: 24,62 23,37 28,31 length: 8,59580052493438
xyz: 24,62 23,37 28,31 xyz: 21,20 23,37 28,31 length: 3,42096445693698
xyz: 21,20 23,37 28,31 xyz: 21,11 23,37 28,31 length: 0,0834381574862668
xyz: 21,11 23,37 28,31 xyz: 21,03 23,37 28,29 length: 0,0861575355274924
xyz: 21,03 23,37 28,29 xyz: 14,19 23,37 22,34 length: 9,06564471045188
xyz: 14,19 23,37 22,34 xyz: 14,10 23,37 22,27 length: 0,110556642810389
xyz: 14,10 23,37 22,27 xyz: 14,02 23,37 22,20 length: 0,110526557850615
xyz: 14,02 23,37 22,20 xyz: 13,94 23,37 22,16 length: 0,0937858051233761
xyz: 13,94 23,37 22,16 xyz: 13,94 23,37 19,72 length: 2,43888602246705
