Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am working in powermill 2017. I am in an assembly mode. I would like to leave the component assembly in its original state. However, what I am looking to do is create a new level, on which that is easy, but I would like to make a copy of the components and put on a new level so I can alter their locations to fit inside of the piece of billet that I am going to be machining them out of. Is this possible? Any feed back would be appreciated. Thanks!
One surface can be assign to only one Level. If you want to organize your surfaces you need to define some "Set"
You can create as many "Sets" as you need. Then It will be easy to select the surfaces for each toolpath via The SMART SELECTION with a selection by Level or Set.
