Due to scheduled maintenance, the Autodesk Community will be inaccessible from 10:00PM PDT on Oct 16th for approximately 1 hour. We appreciate your patience during this time.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
What is the recommended aspect ratio in 3D (100 is what we prefer )
When creating a 3D mesh from a Dual Domain mesh, the maximum aspect ratio before conversion should ideally be below 30:1. The recommended maximum aspect ratio value is 50.
2. In DD we prefer 12 or 20? what Autodesk suggests.
20
3. Is it necessary to solve long edges (some case it's 2000) what will be its effect on the analysis
It is recommended that the number of internal long edges be minimized. It may not be necessary to eliminate all internal long edges if they occur in non critical parts of the mold.
