3D Mesh Repair Wizard - no autostart when opening the wizard

[Anonymous]

In MPI 2016 the 3D Mesh Repair Wizard starts the first mesh diagnostic when the wizard-icon was clicked.

The problem is, that the used settings are not the settings I want to use for this mesh.

So I wait till the diagnostic is done, than I customize the settings and start the diagnostic again.

Is it possible to remove the autostart of the diagnostic and add a "Start diagnostic button"?

Also it is not so time-consuming if you accidentally click on the wizard.

Please add the start button and delete the autostart of the diagnostic.

Best regards
Frank

[madhukeshwart]

May be there must be a  option to do settings configured and saved as default setting .

use the follwing options to 

SettingsOpens a dialog where the target values for the mesh are set. Within this dialog you also have the following options

• Save Current Values - Use the values defined as your default settings. These values only last for the current session.
• Load Saved Values - Re-populate the target values with values saved earlier in the session.