Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
This bracelet is elongated in the wrong (vertical) dimension. I'd like it elongated in the horizontal dimension (so the gap between the ends will be on the bottom of the wrist when worn, not the side). In principle, the easiest way to do that would be to smash it vertically a little bit, shrinking the vertical while lengthening the horizontal. Is there a way to do that in Meshmixer? I can't find one. Thanks for any tips.
This bracelet is elongated in the wrong (vertical) dimension. I'd like it elongated in the horizontal dimension (so the gap between the ends will be on the bottom of the wrist when worn, not the side). In principle, the easiest way to do that would be to smash it vertically a little bit, shrinking the vertical while lengthening the horizontal. Is there a way to do that in Meshmixer? I can't find one. Thanks for any tips.
Never mind, I figured it out. Drag the square at the end of a colored axis bar in the Transform widget on the Edit tab. That lengthens or shortens the object along just that axis.
Never mind, I figured it out. Drag the square at the end of a colored axis bar in the Transform widget on the Edit tab. That lengthens or shortens the object along just that axis.
