I assume you have created the outer circle first, than the inner circle?
What if you switch those two? Is the region still correct?
You should be able to define which region you want for you profile...
"Scott Stubbington" wrote in message
news:B4907FD5F36F4F3E3376DEE54D649D94@in.WebX.maYIadrTaRb...
> Hello,
> I've just created a pipe programmatically, extruded it to a non adaptive
> workplane.
> What's scary is the fact that Inventor has selected the right region. I'm
> also a little concerned by this, how do I specify the correct region? In
> the
> pipe profile I obviously have 2 circles, one for the Outside diameter and
> one for the inside diameter. How did the region between the two circles
get
> picked and not the region that is the the inside of the inside diameter
> circle?
>
> Thanks
>
> Scott
>
>
>