Is it possible to change the margin on a drawingview in VBA?
Is ModelState-->Reference Data --> Margin Accessible?
Tiffany Hayden
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
@HideoYamadaWould it be possible with ilogic? If so I can use VBA to call the ilogic rule.
Tiffany Hayden
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Okay! @HideoYamada I'll look into it. I have posted on the idea board though. Maybe it will get some traction.
Tiffany Hayden
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
@maxim.teleguz No but I talked to a developer at AU this year and I am working with our Autodesk support to get it added. It's now under Investigation! yay!
Tiffany Hayden
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Idea board post:
Tiffany Hayden
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
This is very similar to one of the ideas I posted about back in late 2019 too. My Idea was for some of the other settings on that same tab of the DrawingView dialog.
"Great minds think alike." 😉
Wesley Crihfield
(Not an Autodesk Employee)
@WCrihfield Thanks so much!! I added your idea to my idea. Hopefully, they see that there are lots of people that need this!! Thanks for your support!
Tiffany Hayden
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Very good point!
Tiffany Hayden
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
